MY CART
(Cart is empty)
Welcome to Our Store - Start Shopping

  Home >

Race Glaze Water Filter 0PPM
Race Glaze Water Filter 0PPM


 
Our Price: $229.00



Product Code: 0PPM
Qty:

Description
 

Refillable 0ppm Water Filter (7 litre) - Features

  • Leaves no water spots even without drying off
  • Connects to your hosepipe or pressure washer effortlessly
  • Use to fully wash or just final rinse to reduce usage - the latter for best economy
  • 7 litre capacity, weighs 5kg, 50cm total height
  • Up to 700+ litres of pure filtered water depending on local water hardness
  • Supplied ready to use, pre-filled with resin
  • Refillable with new filtration resin granules - so much lower cost long term - £45 for refills
  • Supplied filled with resin and 3/4" threads for male adapters for Hozelock hosepipe fixings (adapters not supplied)
  • Refilling takes 5 minutes
  • No need to empty vessel of water between washes but advisable to run 2-3 litres through every 2 weeks in summer
  • Shipping to Northern Ireland - due to size/weight there is a supplement of £15 over our standard shipping rate.

Refillable 0ppm Water Filter (7 litre) - Description

We´ve all had to swiftly run round our cars to dry them before water spots form, which are very hard to remove and can badly affect paintwork. And try as you might, washing and drying will cause swirl marks and light surface scratching.

Existing in-line water filters are either very expensive or have incredibly short lives, and can waste the casing, which is very environmentally unfriendly. For example, the AquaGleem filter is 2.5 litre capacity, typically retails at £55. That´s 54% more expensive than our unit costing you 38p per litre. The Race Glaze unit costs 25p per litre, as supplied with its first fill of mineral-absorbing resin,and only 10p per litre with subsequent refills

· !

The new Race Glaze Maxi-Filter uses a durable 11 bar pressure tested fibreglass tank ready filled with 7 litres of premium A1 grade resin (note: some budget filters use sharps - broken reject resin, or are only part filled) and comes ready for you to add standard Hozelock-type connectors (not supplied but available on this website) to begin use immediately.

Mains water comes into the unit and is distributed out from the top strainer into the resin bed, falls under pressure and gravity down through the resin bed and as its only outlet is into the bottom strainer and up the pipe, comes through the resin bed to emerge on the outlet side as close to 0 parts per million (ppm) of dissolved solids as possible.

Using a typical garden hose to wash a car uses approx. 30 litres of water (AutoExpress 21/3/2012), a final rinse only a fraction of that - we estimate 5-7 litres at most.

This is a breakthrough in filtered water product for car washing that is proving to be very popular.

We recommend that a final rinse is performed at half mains pressure, just sufficient to create a wave of water over the vehicle, and should be able to be completed in around 45 seconds for a standard family car, little over a minute for a 4x4. This is based on our own usage over the last 4 years.



OUR PRODUCT REVIEWS
There are dozens of reviews of these products and every one is totally genuine. Customers love them ! The product really is that good. If we added all the good things said about them verbally and on Forums we'd have 3 times as many...

We have carefully selected these taller vessels, in consultation with a water treatment industry veteran, as wider, dumpier (window cleaners) vessels have a lower efficiency and can´t extract the maximum capacity from the resin. This ends up costing you more money. In our tests, our 7L filter produced 59 litres water per litre of resin, over 20% more efficient than the window cleaner 10L unit which produced 48L per litre of resin. So if you're comparing units, add 20% to the price of the dumpy units.

We strongly advise that you check your shed/garage for male adapters and hosepipe-end connectors prior to purchase - though you can buy them from us with your order.

WILL WATER SOFTENERS DO THE SAME THING?
Water Softeners change dissolved hardness into dissolved sodium bicarbonate which removes limescale. However, if you boil off the resultant water you will have a residue at the end of the process - which will be left on your car if you use softened water to wash it and let it dry in the sun.

Our filter totally removes all dissolved solids and there will be nothing left on your car after sun drying. They are different process designed to do different things.



Share your knowledge of this product with other customers... Be the first to write a review
Home  •  About Us  •  My Account  •  Help
Copyright © Detailbest.com, All Rights Reserved. | Volusion Shopping Cart Volusion Templates